Dent Time expalines and shows a little bit on how they removed a fairly deep baseball dent on the corner of the rear quarter panel. The repair took about 3 hours. As most know, dealing with corner dents there is always a lot of tension around the edges. Pushing the dent from behind first did not work. Nor did it help by knocking down as well.
Starting the Dent
It was only obvious that glue pulling was going to play a factor when it came to removing the dent. Pushing from behind would only force it and cause unwanted push marks and jeopardizing the integrity of the finish. About three pulls later, the dent was only a quarter way removed but there was a price to pay. The clear coat was hair-lining. If the dent was pulled any further, it would have pulled the paint right off. The hair-line fractures were barely noticeable and the repair continued.
Crown Releasing
Knocking down the crowns was much easier since now the pressure was taken off. We never really try to do too much at once. Always keeping our dents balanced is one of our key techniques for a successful dent removal. We use a semi sharp knockdown and carefully work the outside. Unfortunately sometimes and knockdown can cause unwanted tap down pits. Although it can be fixed, it just takes more time in the end to finish. We show this on our video tutorial later.
Pushing the Dent
Finally we were able to use a soft tip tool and work from the outside of the dent towards the middle. Now we had to go back n forth between pushing and knocking down. Lastly, we used a sharper tool to pin point all the mistaps caused by the sharp crowns. Indeed it was tedious but it had to be done. 3 hours later it was completed. Video coming soon..
1 comment:
We never really try to do too much at once. Always keeping our dents balanced is one of our key techniques for a successful dent removal.
Dent Repair Orange County
Post a Comment